The walls of houses usually appear blistering, falling off, yellowing, and other phenomena after living for many years, which not only affect the overall beauty of the house, but also cause problems throughout the entire wall. Therefore, the renovation of the wall is extremely necessary. How to refurbish the wall quickly? What are the steps involved in renovating the wall? We introduce all the steps to remodel a wall in this article and the issues that need attention in the renovation of the wall. Guide to Wall Remodelling - Steps on how to renovate interior walls 1. Detection of the Wall The situation of the wall, such as whether the wall is damp and the pH value, needs to be detected prior to renovating the wall. In general, these tests use special tools, humidity instruments can be used to detect wall moisture, pH can be used to test paper to determine the value of the value according to the color. 2. Please clean the wall, It means that the salt in the wall is precipitated if there is fine white powder on the wall. It is suggested at this point that you can brush it with a nylon brush or an iron brush. After a few days of observation, it is confirmed that no precipitated white powder is present, and the cement wall can be painted after it has been dried and polished. If the white powder is more and more continuously precipitated on the surface of the cement wall, a layer of wall primer may be applied after cleaning to prevent salt erosion in the future. Also, brush or decorate within three months without using oily paint or waterproof wallpaper. 3. Remove the peeling film from the In order to remove the peeling paint film on the wall, you can use a knife or iron brush and then use sandpaper to smooth the wall surface. 4. Delete the wallpaper & wall tiles that were pasted Take down the wallpaper or tiles installed on the wall when painting the wall, otherwise the location covered by the wallpaper will not be visible. 5. Get the surface finished If the surface of the wall is trimmed with a soil knife, stains, cracks, blisters, and other phenomena that should be addressed in time will appear on some walls. 6. Apply primer Use primer Sealing the base material, resisting alkali and moisture, protecting the topcoat, and improving the texture and covering power of the topcoat are the functions of the wall primer. The wall must be prepared for the decoration of ancient houses. The wall is more likely to blister and mildew if it is painted directly, and it is easier to change color after a long period of time in the sun. 7. Painting Painted This is the simplest way to decorate the wall and the most common way. You should start from the top when brushing the wall, and then brush down, otherwise it will cause the paint to drip and flower the completed wall.